100V10A 50W 전자부하
전원장치나 모터드라이버의 부하구동성능을 시험할때 사용하는 장치입니다.
최대인가전압, 최대인가전류,최대인가전력은 출력 FET와 방열판에 따라서 달라집니다.
제어부 및 표시부를 MPU+PWM+LCD로 바꾸어 만들면 더욱 좋습니다.
This power load is suitable for testing power supplies to 100V and 10 Amps.
Power dissipation is limited to 50 Watts continuous and 150 Watts
for short periods of time.
The power load chassis is constructed from a 6 inch tall heat sink extrusion.
The extrusion used had a slot cut in it that the front panel slips into.
The circuitry is built on this front panel. The top and bottom panels,
screw into the fins and hold the front panel in place.
In the back view the IRF150 pass transistor can be seen.
The knob controls the current that loads the power supply under test.
One switch controls the power, the other switch changes the meter
from reading the current to reading the voltage at the input terminals.
The battery on the side is used to power the FET driver. having this battery
on the outside of the load allows quick changing in case someone leaves the load
on over a long weekend, draining the battery.
The load is useful in a lab environment to quickly check the output of a power supply.
The load works by adjusting the voltage across a precision current sense resistor
to be the same as the reference voltage set by the knob.
This provides a constant current output that is not affected by the load voltage.
Schematic in PDF format: Load.PDF
100V10A50W 전자부하 회로도
Steve Hageman 14,Sep, 1997.
|TCS230 색상검출 평가키트|
|FLAME SENSOR UVTRON R2868|